Q?: How much costs to unlock IMEI Cat B30 T-Mobile network carrier?
A!: It will only cost you 13.99£ with no further additional payments. That’s all.
Q?: Will this unlocking service work for sure?
A!: Of course, we unlock IMEI Cat B30 T-Mobile within maximum 48h. We performed over 200.000 unlocks already!
Q?: Is this permanent? What if I update my firmware?
A!: Our service is a permanent solution for your device. You can update your firmware and it will never get locked again.
Q?: How do I get notified when my Cat B30 is unlocked?
A!: You will receive an e-mail confirmation with easy-to-follow instructions on how to activate your unlock on the device.
Q?: This works for any Android software version of Cat B30?
A!: Absolutely, works for any version and will keep unlocked if you upgrade your software in the future.
• If you travel, buy a local SIM card and save on roaming fees.
• The resale value of your Cat phone will increase significantly as it is available to more operators.
• Easily switch between SIM cards, using the same phone.
• Unlock your phone from the comfort of your home
• There is absolutely no risk of damaging your Cat Phone by unlocking it.
• Very easy, without necessary technical experience.
• The phone is unlocked permanently, even after updates
To apply/enter Cat unlock code in your phone there are two paths to follow after you have obtained your unlock code. The two ways are presented below:
Unlocking your Cat code phone, it is very easy after getting your unlock code in unlockcellphone, it does not require technical knowledge or difficult software.
After having your unlock code just follow the following steps:
And ready! This is it, your cat phone is unlocked and you can use it for any network.
Don’t hesitate to ask Unlocki.ng team if you have any issue entering your unlock code. We offer 24h chat support and fast reply ticket support. We will be pleased to help you in order to get your device unlocked. Visit our unlock shop if you still don’t have your unlock code.
[RICH_REVIEWS_SHOW category=”all” num=”all”]